DEFINITION OF THE PRODUCT: Mat paint in a solvent medium, basically made of epoxy resins and amine hardener, having a big binding power, of penetration and consolidation of supports that are basically made of hydraulic binders (concrete, cement coating, chapes, etc.
DESTINATION OF THE PRODUCT: for all works of consolidation of floors that are basically made of friable or chalking hydraulic binders, before painting.
PARTICULAR ADVANTAGES:
- Excellent penetration in absorbing backgrounds; a product that cannot be transformed into soap. It can be therefore directly applied on all alkaline support (cement coating, asbestos cement, and concrete)
- It plays the role of a regulator under-layer of absorption, which is adherent and semi-opaque.
- Excellent binding power; which allows a very good hardening of the backgrounds and it blocks the laitance of the concrete and the cement coatings before painting.
SUPPORT:
It is applied on all supports that are basically made of safe and dry hydraulic binders:
Concrete, cement coatings, asbestos cement. It can be applied on metallic supports (limited interest)
CHARACTERISTICS OF THE PRODUCT BEFORE USING THE PRODUCT;
The product is presented in two parts: base and hardener
- Base
Tint: white
Aspect: stretched white
Density: 1,58+-0,1
Viscosity upon delivery: 65 KU +-5 at 25 degrees Celsius
- Hardener:
Tint: colorless, lightly yellowish
Aspect: stretched mat
Density: 1,00 +-0,1
Viscosity upon delivery: not applicable
Presentation: Base: 20 kg
Hardener: 3 kg
Dosage ratio: 2okg/3kg
Storage: 6 months in the original pack, closed and away from bad weather
Sanitary precautions: wearing gloves, glasses and a mask
Characteristics of using the product:
Make the mixture: Base 20kg, hardener: 3kg. Homogenate well and wait 10 mn before application
Properties of the product upon application
Once the mixture: base-hardener is done
Tints: white
Storage: Pot. Life of 6 hours at 20 degrees Celsius. After this delay, the product starts to thicken and ends up hardening in the pack
Viscosity: liquid product
PRECAUTIONS OF USING THE PRODUCT
-Stir the product from time to time during the application to keep it homogeneous.
–Apply the product on safe, dry and dust free backgrounds.
-This product is insensitive to gel and to water once it is applied. But it must be applied on perfectly dried backgrounds.
HOW TO USE THE PRODUCT
Application: Brush or roller. It can be applied with an airless pistol
Diluent: Cellulosic diluent
Dilution: ready to use for brush or roller
Cleaning of the material: Cellulosic diluent
CHARACTERISTICS
Nature: epoxy resin, amine hardener
Aspect: stretched mat
Drying:-at 20 degrees Celsius with 60% relative humidity
-Away from dust
-Dry: 2 h
-Recoverable: 24 h
Consumption: 6 to 8 meters squared per kg in one layer. This consumption depends on the porosity of the support
Adherence: very good
Penetration: excellent
Binding power: excellent
This product is inflammable and is insensitive to gel.
NOTE: The characteristics of our products are published for general information. In case the circumstances of using the product go beyond our control, we decline any responsibility for any eventual damage.
